Справочная информация и описание кабеля
ST506/412
The ST506/412 interface requires two cables, one for control
and one for data. The control cable is shared between the two
drives. But each drive has each own data cable. By twisting some
wires on the control cable it won’t be necessary to set the ID
for each drive, since the twist will do the job. Wires 25 to 29
should be twisted between drive 1 & drive 2.
Controller Drive 2 Twist Drive 1
+—+ +—+ +—+
|::|===================| |============| | <-Pin 1
|::|===================| |============| |
|::|===================| |============| |
|::|===================| |============| |
|::|===================| |=====/=====| |
|::|===================| |=====/=====| |
|::|===================| |============| |
+—+ +—+ +—+
Control cable
(to the Controller)
(to the Drive 2)
(to the Drive 1)
34 PIN IDC FEMALE to the Controller.
34 PIN IDC FEMALE to the Drive 2.
34 PIN IDC FEMALE to the Drive 1.
Controller
Drive 1
Drive 2
Wire 1-24
1-9
1-9
1-9
Wire 25
25
29
25
Wire 26
26
28
26
Wire 27
27
27
27
Wire 28
28
26
28
Wire 29
29
25
29
Wire 30-34
30-34
30-34
30-34
Data cable
(to the Controller)
(to the Drive)
20 PIN IDC FEMALE to the Controller.
20 PIN IDC FEMALE to the Drive.
Controller
Drive
Wire 1-20
1-20
1-20
Contributor:
Joakim Цgren
Source:
TheRef TechTalk
Copyright © The Hardware Book Team 1996-2004.
May be copied and redistributed, partially or in whole, as appropriate.
Document last modified: 2002-01-10