Справочная информация и описание кабеля
IDE
The IDE interface requires only one cable. All pins straight
from 1 to 1, 2 to 2 and so on. The drives can be connected in any
order. Only remember that one should be jumpered as Master and
the other as Slave. If only one drive is used, jumper it as
Single (if such a mode exists, or most common Master else).
Controller Drive 1 or 2 Drive 1 or 2
+—+ +—+ +—+
|::|===================|::|============|::| <-Pin 1
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
+—+ +—+ +—+
(to the Controller)
(to the Drive 1)
(to the Drive 2)
40 PIN IDC FEMALE to the Controller.
40 PIN IDC FEMALE to the Drive 1.
40 PIN IDC FEMALE to the Drive 2.
Controller
Drive 1
Drive 2
Wire 1-40
1-40
1-40
1-40
Contributor:
Joakim Цgren
Source:
?
Copyright © The Hardware Book Team 1996-2004.
May be copied and redistributed, partially or in whole, as appropriate.
Document last modified: 2002-01-10